Hi: I have a Denon 5800 with a Sunfire Cinema Grand powering the front 5 channels at 200 x 5. The Denon and Sunfire are on their own 20-amp circuit. The reset of my components are plugged into a Monster HTPS 7000 and work fine. Today, I played some music at reference level in 7-channel stereo...
Hi: Is it better to have the gain on each sub set to max and then calibrate it with DVD test tones? P.S. I have Def Tech BP 2000's and an Infinity Intermezzo 1.6s Thanks, Chris
Hi: I've had my Pioneer Pro 610 HD set for about 1.5 years now. I'm finally thinking about getting it calibrated. I have a Hi-Def Sat receiver & a progressive scan DVD-Changer. I want the best picture possible. What can/should I ask to be done & how much can I expect to pay? What should...
OK, I just rewired my home theater to clean up the wire monster back there. It is a dedicated room with in-wall 14-4 ga. speaker wire and an in-wall equipment rack. However, I'm STILL having a problem with low-level hum whenever my amp is on. I tested it with nothing hooked up except Monster...
Hi:
I have an Onkyo TX-DS 939 powering 6 Def Tech. inwalls with 3 Niles Audio Intellipads. The Onkyo has a 6-ohm load minimum. My problem is, one set of speakers is connected to the center channel & one set is connected to the L & R surrounds. Well, the sound isn't the same from the center...
Hi:
I have an Onkyo 939 receiver that I am using to power speakers in multiple rooms. The lowest "rated" impedence is 6 ohms. I was wondering if it would be OK to run 6 8-ohm speakers into three channels, or would it be too much for the Onkyo? It's rated at 100 w x 5 @ 8 ohms. I'd only be...
Has anyone seen any reviews on this one yet? I am wondering if it would be worth an upgrade. I currently have an Onkyo DV-M301 changer (non-progressive) with a Pioneer Elite Pro-610HD.
Chris
I had posted before about my speakers humming when using my system. Someone replied and told me it might be a ground loop. I figured out that it was my tv (Elite Pro 610), that was causing the problem. Everytime I turn it on they start humming. I have BP2000's. Would pulling the speakers...
Hi:
I have Def Tech BP2000's hooked up to a Sunfire Cinema Grand Amp. I am noticing speaker hum/hiss when using my system. I have the amp set to auto-on. It goes away when the amp shuts off. Is there any particular reason why this is happening? Is it bad for the speakers? What is the best...
Hi:
I have a question regarding sub calibration? I am using a Denon 5800 & have Def Tech. BP2000's and a Infinity Intermezzo 1.2s for subs. How exactly should I have the sub volumes on the subs when trying to calibrate? Half, quarter, etc? Right now the volumes on each sub are way down. On...
Hi:
I was wondering how you run S-Video in wall & terminate them to wall plates? I know for component you just run 3 separate RG6 cables per input.
Thanks for your input.
Chris