Dustin Wind
Stunt Coordinator
- Joined
- Aug 19, 2003
- Messages
- 158
Hi all,
Just wondering how i would go about Calibrating my 10" Velodyne Sub.
What do i set the following to:
Knob 1: Low pass Crossover - goes from 40hz to 120 hz
Knob 2: subwoofer volume
Then there is also the "phase" and "internal x-over"
Also the "high-pass crossover" which is either 80hz or 100hz.
I have a Yamaha 5450 receiver.
For the front speakers i have JBL N26, but as of tommorow i think i'm going to get the JBL ND310II.
My backs right now are N24's but if i get the ND310II then i will use the N26's as the back and one of my N24's as the 6th speaker.
My center is the JBL N-center.
So i know with my sound pressure reader i want the sub test volume to be 80DB (from reading the forums).
But where do i begin? Where should i set the knobs? do i put the high pass crossover at 80 or 100?
Should i put my BASS volume on the receiver at 0 then turn up the knob VOLUME on the sub until i'm reading 80DB....or?
If so then where do i set "low pass crossover" to?
Thanks a ton guys.
Just wondering how i would go about Calibrating my 10" Velodyne Sub.
What do i set the following to:
Knob 1: Low pass Crossover - goes from 40hz to 120 hz
Knob 2: subwoofer volume
Then there is also the "phase" and "internal x-over"
Also the "high-pass crossover" which is either 80hz or 100hz.
I have a Yamaha 5450 receiver.
For the front speakers i have JBL N26, but as of tommorow i think i'm going to get the JBL ND310II.
My backs right now are N24's but if i get the ND310II then i will use the N26's as the back and one of my N24's as the 6th speaker.
My center is the JBL N-center.
So i know with my sound pressure reader i want the sub test volume to be 80DB (from reading the forums).
But where do i begin? Where should i set the knobs? do i put the high pass crossover at 80 or 100?
Should i put my BASS volume on the receiver at 0 then turn up the knob VOLUME on the sub until i'm reading 80DB....or?
If so then where do i set "low pass crossover" to?
Thanks a ton guys.