Jump to content

Sign up for a free account to remove the pop-up ads

Signing up for an account is fast and free. As a member you can join in the conversation, enter contests and remove the pop-up ads that guests get. Click here to create your free account.

- - - - -

Few Flexi Rack questions

  • You cannot start a new topic
  • Please log in to reply
2 replies to this topic

#1 of 3 OFFLINE   RobCar


    Stunt Coordinator

  • 201 posts
  • Join Date: Nov 27 2002

Posted April 23 2003 - 08:08 AM

Been reading through the past posts about building one of these racks, and I think I'm going to give it a shot. I'm not really that handy, but I'm cheap and I want to save the $$. Thinking about making mine 20" x 20". I'm wondering about the feet though. What do people put on the bottom of the rods? And is it possible to put casters on the feet, so I can roll the unit out from the wall to make connection changes etc? Or is that just not done?

#2 of 3 OFFLINE   MarcVH


    Second Unit

  • 324 posts
  • Join Date: Dec 26 2001

Posted April 23 2003 - 10:19 AM

I just put little rubber caps on the bottom. Casters might be possible, but they should be mounted to the rods rather than to the bottom shelf.

#3 of 3 OFFLINE   Ryan Schnacke

Ryan Schnacke

    Supporting Actor

  • 877 posts
  • Join Date: Feb 05 2001

Posted April 23 2003 - 04:03 PM

I've done both the rubber caps and the casters. I did mount the castors to the bottom shelf, but I did at least mount them as close to the rods as possible to minimize the flexing of the wood from the horizontal transfer of the vertical load. It difficult to find castors that will connect to 5/8" all-thread. And it seemed impossible to do that and keep a low-profile (minimal space between the bottom shelf and the floor). My 3/4 inch birch ply had no problems for the year it was loaded with my audio equipment plus a 32" TV. This was a double-wide flexy with 6 rods and 6 castors. I have no doubts that it could bear that load for a couple of decades. MDF might flex a little easier than birch ply, though.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users