Eric Schriver
Auditioning
- Joined
- Jul 29, 2004
- Messages
- 3
Hey everyone,
I've been lurking on this forum for some time now, but I've reached somewhat of a problem. I've purchased my MDF, drivers, and sonotube, but for the life of me I can't cut my end caps. I attempted using a Craftsman router with a Bosch bit. The problem is I got about 1/4 of the way around my 20" diameter cap and the bit was dull and would no longer cut. I know the answer is probably simple, but I must be missing it and only have a limited time to complete this before going back to college. How did you guys cut your caps? Thanks.
I've been lurking on this forum for some time now, but I've reached somewhat of a problem. I've purchased my MDF, drivers, and sonotube, but for the life of me I can't cut my end caps. I attempted using a Craftsman router with a Bosch bit. The problem is I got about 1/4 of the way around my 20" diameter cap and the bit was dull and would no longer cut. I know the answer is probably simple, but I must be missing it and only have a limited time to complete this before going back to college. How did you guys cut your caps? Thanks.