B&K Setup software problem

Discussion in 'Archived Threads 2001-2004' started by Rob Lloyd, Sep 12, 2001.

  1. Rob Lloyd

    Rob Lloyd Stunt Coordinator

    Joined:
    Mar 22, 2001
    Messages:
    234
    Likes Received:
    0
    I installed the B&K setup software, made the connector etc to my 307. When I start to run it, it says it found an AVR307 on Com1. Then says it's "interrogating device". This goes on for about 20 minutes before I close the program. Is it normal to take that long?
    Am I missing a wire connection or something?
    This is on a laptop w/o any other com devices (like a Palm).
    Thanks,
    Rob
     
  2. Pete Mazz

    Pete Mazz Supporting Actor

    Joined:
    May 17, 2000
    Messages:
    761
    Likes Received:
    0
    I have experienced intermittent problems with the software. A full power down and it's back in business. It really acts more like a computer every day. [​IMG]
    BTW, what baud rate does it connect at? I set mine to 115,000, and it works great (usually).
    Pete
    ------------------
     
  3. Rob Lloyd

    Rob Lloyd Stunt Coordinator

    Joined:
    Mar 22, 2001
    Messages:
    234
    Likes Received:
    0
    Thanks. I'll try that when I get home. I hope that is it. I keep forgetting that it may need a re-boot once in a while. I rebooted the laptop just not the 307. I did have it on 9600 and then changed to 115k with the same results each time.
    -Rob
     

Share This Page