Hi everyone - new to the HT scene and trying to figure out wiring bass shakers.
I have a RX-A840 as a receiver
I have 2 Clark Synthesis transducers (TST239) and plan on buying 4 more soon. Specs :
I am planning on buying an amp (Parts Express recommended Crown XLS 1002 and others are recommending the inuke) but not sure how the wiring would work (initially 2 and then eventually 6 shakers). Can I just use of the channels of the amp and turn down the wattage ?
Clark synthesis site shows 2 of them to have amp rated 150-200 watts per channel at 4 ohms or rated 75-100 watts at 8 ohms.
I have a RX-A840 as a receiver
I have 2 Clark Synthesis transducers (TST239) and plan on buying 4 more soon. Specs :
- Continuous power handling: 100 watts
- Impedance: 4 ohms
- Overload Protection: Polyswitch
- Frequency Response: 15Hz to 17kHz
- Electrical Connection: 3ft. – 16/2 wire
- Dimensions: 8 in. diam. x 2.25 in. high
- Recommended Amplification: 75 – 100 watts at 4 ohms
I am planning on buying an amp (Parts Express recommended Crown XLS 1002 and others are recommending the inuke) but not sure how the wiring would work (initially 2 and then eventually 6 shakers). Can I just use of the channels of the amp and turn down the wattage ?
Clark synthesis site shows 2 of them to have amp rated 150-200 watts per channel at 4 ohms or rated 75-100 watts at 8 ohms.