Hi - I've had an Anthem AVM 20 (V 1.12) for nearly 2 years now. So far I couldn't be happier with it. Just recently, I mated it with a MCA 50. All of the sudden, in the last week or so, its been behaving strangely. Nothing has changed in my system except the new MCA50 amp last month...
I'm with Michael - this is making me a little nervous as Evan's was a 'late production model' with the slo blo fuses installed.
Wasn't Anthem's official response that this problem was completely resolved by replacing the main fast blow fuse with a slo blow fuse?
Evan - was it an involved...
Check out the Nakamichi Soundspace 3 - pretty full featured with dual units each with clock display for each side of the bed + sub:
http://www.nakamichi.com/soundspace/SS3/SS3.HTM
Legairre -
Ouch. Thats too bad - I've felt your pain. I waited many moons for my AVM20. But it was well worth the wait as I'm sure your 1066 will be. Stay strong!
As long as you're auditioning ... why not go hog wild and throw a 1066 into the mix while you're at it?! Legairre?
Can't wait to read about the results ..
Thanks for the input Warren. For now, my rears are used just as surrounds for HT (they are on the list for upgrading). Their freq response is 65-20,000 Hz, sensitivity is 88 dB SPL/W/m, impedence is 8 ohms.
I have no sub in my system yet so I have my fronts set to large. I'm using Kef Reference...
Hi, I'm looking for a cost effective amp to replace an ailing 2 ch amp for my rear surrounds. I've been considering the B&K ST 2140 (140 W/ch) and the B&K ST 260 (60W/ch). The ST260 is very reasonably priced (