Recent content by Duke72

  1. Duke72

    universal remote question

    I'm wanting to get a good remote to control my HT, I like the Logitec harmony 1000. Is that a good one? I like the idea of the touch screen, but i don't like the fact that you have to get an RF extender to control lights. Any suggestions?
  2. Duke72

    Center makes a buzz sound

    I have a infinity cascade C3 center hooked up to a HK reciever and when I turn it fairly loud to watch a movie it makes a buzzing or humming sound. It has 4 connectors on the back, and the book did give a option to bridge. Do I need to do that?
  3. Duke72

    Set up question

    The receiver I bought (Harmon Kardon AVR 445) is supposed to have a built in audio calibrator. Is that the same thing or does it just make sure the sound is getting to the right spot? if not what is a spl meter and how much does something like that run?
  4. Duke72

    Set up question

    thanks, using the THX helped. If I were to get one of the more advanced disc to callibrate, which one is best? Or are they pretty much the same?
  5. Duke72

    Set up question

    Just finished setting up my projector (Panasonic AX-100U) and the picture is not as sharp as I thought. I have a draper 106" onxy fixed frame screen. the instructions aren't clear about how to fine tune the projector. or could it be the dvd player? they sent me an OPPO dvd player, is that junk?
  6. Duke72

    Room size for home theatre

    Try this, it helped me http://www.myhometheater.homestead.c...alculator.html
  7. Duke72

    Hey guys, almost finished building. Trim out question.

    I was about to order my audio equip. when I found out I have a great hook-up on infinity speakers and Harmon Kardon recievers. The speakers (Infinity HV250's) are in-wall flush-mount and have 2 5" drivers w/ a CMMA tweeter, the center is the new cascade. It's a $500.00 center that I can get for...
  8. Duke72

    Pre-wire question

    Thanks
  9. Duke72

    Pre-wire question

    Thanks, Should I consider a rear center?
  10. Duke72

    Pre-wire question

    I ran my wire this past weekend, and have a question. Bob told me NOT to run my surround w/ the rg6 because it was line level, which I didn't, but my question is: I have 2- 2" conduit running down the wall where my amp will be, in one I have the rg6 for the sub and the other I have all the...
  11. Duke72

    pre-wire question/ starting tommorow

    I am prewiring for 5.1, w/ 14 ga cl3 non-oxygen free wire, I am putting in wall flush mounts. Should my surrounds be facing the front speakers on the back wall, or facing inward from the side wall? Also, is this wire OK for the sub?
  12. Duke72

    Prewire is 16 ga. enough?

    Adam thanks also for the reply on the ps3.
  13. Duke72

    Prewire is 16 ga. enough?

    Thanks for the info, I'm going today to change out the wire.
Top