Stephen Dodds
Second Unit
- Joined
- Aug 29, 1998
- Messages
- 354
This came up at AVS in the big Stryke thread, but without much response, so I thought I'd try here.
A guy asked about having an aluminium enclosure built, and this intrigued me enough to get the details of where it could be done. It is not too far from me.
John Janowitz couldn't think of any real positives to doing this, but I'm interested in any negatives anyone can think of.
I'm looking at the 22 inch cube 15.2 design. I like the thought of aluminium because it would fit in with my decor (ultramodern). I would also imagine it would be lighter than the MDF enclosure.
The main negative I can think of is that unless the Al is very thick, it would be difficult to countersink the drivers.
Anyone have any thoughts or suggestions?
Thanks
Steve
------------------
Link Removed
A guy asked about having an aluminium enclosure built, and this intrigued me enough to get the details of where it could be done. It is not too far from me.
John Janowitz couldn't think of any real positives to doing this, but I'm interested in any negatives anyone can think of.
I'm looking at the 22 inch cube 15.2 design. I like the thought of aluminium because it would fit in with my decor (ultramodern). I would also imagine it would be lighter than the MDF enclosure.
The main negative I can think of is that unless the Al is very thick, it would be difficult to countersink the drivers.
Anyone have any thoughts or suggestions?
Thanks
Steve
------------------
Link Removed