Recent content by Eric Schriver

I would use a 1/2" shaft if I could but the collet on my router is only a 1/4". One bit if properly used should get the job done though, correct?

Alright I think I got this down. I have a bandsaw at my disposal that I'll use for the outside cut... Thanks all for the help... If anyone else has anymore pointers keep them coming.

Hey everyone, I've been lurking on this forum for some time now, but I've reached somewhat of a problem. I've purchased my MDF, drivers, and sonotube, but for the life of me I can't cut my end caps. I attempted using a Craftsman router with a Bosch bit. The problem is I got about 1/4 of the...