Recent content by gfdyna

Nothing enhances living pleasure quite like a room full of engulfing sound vibrations from music and movies that penetrate the very soul. And nothing could maximize that experience quite like adding the Denon X5200W 9.2 channel Dolby Atmos AV Receiver and a couple of quality ceiling speakers to...

Sounds that surround, accenting the detail of every musical or theatrical movie expression, truly is the worth of any home entertainment center. The Onkyu Dolby Atmos Receiver would be the final component needed in my home entertainment center to generate and maximize the sound pleasure for my...

Brent, Just had an electrician over and he suggested two dedicated 20 Amp lines, one for each Sunfire. That sounds like overkill but I may do that just to have the peace of mind that you mentioned. I would then have three dedicated lines 1 - 15 amp and two 20 amp, plenty for anything I will...

I have several Panamax 1000s which have two outlets on each unit that are designated as "delayed on" outlets intended for power amps. Do you think this is the same as what you are referring to as "high wattage" outles?

Thank you for the response. I have tripped the 15 amp breaker once and that happened upon turning on the system, all running through Panamax surge protectors. It has only happened once so far but happened shortly after adding the Sunfire 5X425 power amp (15 amp), thus the reason for my inquiry...

I have the following equipment that is connected to a 15 amp dedicated power supply home circuit: 1. Two Sunfire Power Amplifiers - 1800 watts power consumption each 2. NAD 2700 Power Amplifier - 970 watts 3. NAD 2400 Power Amplifier - 390 watts 4. NAD 902 bridged - 240 watts 5. Sunfire...

I have Sunfire Power Amps (5X425 & 5X200) that I plan to run through Panamax surge protectors/line conditioner. I was advised that the Sunfire amps may perform line conditioning functions and should not be ran through surge protectors that also perform similar such functions. I could not see...