Recent content by BadRabbit

Cushion. I didn't have a tripod available (though I've found one since). Is that my issue? Easily solved if so.

I've run YPAO on my Yamaha V377 and it gives me 1ft as the distance for my sub (it's about 9 ft away) . Now I realize that sub distance is sometimes not physical distance but I thought it was usually further than actual distance not much shorter. Should I adjust this or leave it alone?

Ended up being a bad BD player. Replaced it and now everything is working. Thanks to everyone for their help.

Yes. My fault that I didn't state that clearly. I just need the video to the TV but the problem was that if I changed the receiver to the digital audio channel (AV1) the screen went blank (as I assume the receiver was trying to output the video through component and the only link from the...

Yeah I was thinking those stated throughputs were far beyond necessary. Like buying a production car that does 200 mph and driving it in NYC.Edit: I guess the more apt analogy would be building Talladega Motor Speedway for horse and carriage racing.

I Is it possible to take the Video from an HDMI input (HDMI 1) and the optical audio in (AV1) and output it through the HDMI out on a Yamaha RX-V377? There doesn't seem to be any indication that is possible in the manual but wanted to ask before buying a converter.Uverse's STB will only output...

I generally buy the premiums from Monoprice and they are very inexpensive and I agree the expensive ones don't seem to make a difference. I was mainly asking about the standards (1.3a, 1.4, etc) in case there were multiple standards of HDMI available (similar to how Ethernet is available in Cat...

OK. I'm going to pick up a new HDMI on the way home just in case. I'm not sure how old the ones I have are. If not I'll try a factory reset and then reconnect all HDMI "cold". BTW, I see people mention HDMI by standard version number (e.g. 1.3a) but that spec never seems to be located on...

I have used the Roku with plex sending DTS 5.1 audio on the same HDMI cord to check it with no problems so I think the HDMI is fine. I did not plug the Yamaha in until everything was hooked up. The TV and BD player were both plugged into a strip but the strip was turned off. I assumed that was...

OK My BD player is not as old as I thought, 2012. Manual linked below. https://docs.sony.com/release/BDPS590_BX59.pdfI set toAudio HDMI : AutoBD Audio Mix: OffDolby Digital DTS: BitstreamDTS Neo:6 OffAudio DRC: AutoDownmix: SurroundI still get the same issue. I have noticed now that every time...

OK. I'll try that tonight. If it doesn't work, I'll post additional info on the player (it is at least 3 years old).Thank you.

Sorry, I meant to include that the problem started before I set impedance (which I originally thought was the issue) but it happens at 8 ohm and 6 ohm.I'll try the crossover again but wouldn't a crossover issue cause issues across all the sources? My media on my NAS that I play over ROKU has the...

Not home right now to check but I believe the receiver said PCM which means the player is decoding, right?

I just put in an RX-V377 Yamaha receiver and a 5.1 Yamaha speaker package (4 small frontsurrounds, center and active sub). Ran YPAO and made minimal other adjustments. Everything works fine when I'm watching cable or my Roku but anything played on the Sony Blu-Ray player cuts out over and over...