-

Jump to content



Photo
- - - - -

Setting up Harman Kardon AVR247 remote?


  • You cannot start a new topic
  • Please log in to reply
1 reply to this topic

#1 of 2 OFFLINE   Jlloyd

Jlloyd

    Auditioning

  • 1 posts
  • Join Date: Sep 05 2012

Posted September 05 2012 - 07:32 AM

I have recently installed an HK AVR 247 receiver with surround sound and connected TV, DVD and (comcast) cable box. All is well, EXCEPT for the following: 1. The only buttons on the remote unit for the HK AVR247 which appear to work are the source buttons near the top of the unit (HDMI 1, DVD, VID 1 etc). None of the others have any impact - volume, channel...even the power on/off!. Any ideas? (Batteries are fresh and the receiver visibly picks up the signal). 2. I cannot control any of the connected devices through the HK remote unit once I select them....and need to operate each of them with their own, original remote control units - the TV, DVD and cable box - how do I get the HK remote to take over control? Final question if anyone can help - can I connect my pc to the HK receiver to then run and control Netflix streaming onto my TV? My pc has no HDMI port so I am not sure how I can connect it (I think the RS-232 serial port is data only?) Thanks!

#2 of 2 OFFLINE   schan1269

schan1269

    HTF Expert

  • 13,929 posts
  • Join Date: Jul 04 2012
  • Real Name:Sam
  • LocationChicago-ish/NW Indiana

Posted September 05 2012 - 08:23 AM

Page 58 of your owners manual... Then page 68-73 The receiver has HDMI upconversion, so you could use this for the video... http://www.amazon.co...s=vga component (or similar to take VGA to component) Since the receiver only has two HDMI, and I assume you are using both... http://www.amazon.co...component video




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users