Hey all, I'm building a set of MTMs and I had a quick question regarding Hurricane Nuts. On my sub project (in finishing phase) I didn't use any backer on my hurricane nuts when installing. Unfortunatly, I pulled out two hurricane nuts during the process (when testing the screws). I was using...
Hello all, It has been a LOONNGG time since I posted. I finally have enough of a break to try to finish my thunder 12.3 cabinet. A little problem popped up. I cut the drive openings to the specs in the design I recieved from Stryke, but the PR and Subwoofers will not fit in the holes...
Hello all, Quick question. I want to router out 3/4" on the top and bottom edges of my sub box so I can put 3/4" walnut strips in there. That way the sub will match my mains, oak with walnut strips. Any suggestions on the best way to do this?? Would a 3/4" rabbit bit at a 3/4" depth be the...
Hey all- Well I've finally gotten around to nearly completing my Thunder 12.3 box. (Outer side panels glue tonight) Now I need to think about the finish. I was searching through the threads here and it looks like one of the best places to shop is tapeease.com. Ok, so I'm looking at the...
Hey all, Well, my table saw connection fell through so now I've resorted to cutting my MDF with a circular saw and a straightedge. It is working ok thus far but the one thing that is annoying is at the end of the cut it seems the edges aren't 90 up/down (the 3/4" width). Anyone have hints on...
Hey everyone. I've been doing some searching here in the DIY section in regards to the Av12 and enclosure options. I actually purchased two av12s in the first preorder and now have decided to build new enclosues for them. I do listen to music but I spend the most time watching movies...
Hello all-
I'm new here so take it easy on me! :)
I've read the sticky at the top of the forum and I think I might be ok with this question.
I'm looking for a new 12" driver for my HT setup.
Right now I'm using two identical "cubes" each consists of:
JL 12W1...