I will be connecting an RX-A1000 receiver to a 5-channel amplifier using the Front, Center and Surround Pre-Outs. HDMI video in from a Cable Box (DVR) and from a Blueray Player. HDMI video out to a Panasonic Plasma tv. While watching tv or Blueray in my living room, I would like to be able to...
I've gone brain dead. I should know the answer to this question, but I cannot think. I have an Anthem MCA50 amplifier, 180x5. Can I connect 4 Ohm main speakers and 8 Ohm center and surround speakers without causing any problems? Are there any settings that need to be made on the amp?
Since the volume of a powered subwoofer can be controlled by both a physical knob on the back of the sub and by a subwoofer volume setting within a receiver or pre/pro, it is my guess that the receiver or pre/pro setting should be set to its midpoint of the range and then the volume control on...
I just purchased an Anthem AVM 20 and read an insert included with the unit that says, "The use of an adequate and approved surge protector is highly recommended". It goes on to state, "Do not use a power line conditioner...". I have all of my equipment, including my Anthem MCA 50 amplifier...
I am curious as to whether HT/Audio enthusiasts are making a switch to Silver face plates on components vs the traditional Black units. I am about to purchase the Anthem AVM 20 and have yet to decide which color to get. I like the looks of the "brushed aluminum" unit, but all of my current...
I am interested in placing an Outlaw ICBM between my Yamaha RX-V995 (used as a pre/pro) and my Anthem MCA 50 five channel amplifier. However, I am a bit confused about what I have read in this forum regarding "time delay" and the inability to compensate for speaker placement. From my Yamaha...
I have a Yamaha RX-V995 receiver feeding an Anthem MCA 50 five channel amp from pre-outs on the receiver. I also have two outdoor speakers being fed from the receiver's "B" speaker outputs. The signal for the outdoor speakers goes through a volume control switch mounted outside. Prior to adding...
I've read numerous threads regarding SMALL vs LARGE speaker settings and have never seen anyone question the use of a multi-channel amp using the SMALL settings. Here is my pertinent equipment: Anthem MCA 50 Amp (180x5) Yamaha RX-V995 Receiver (used as pre/pro) Paradigm Monitor 9 mains...
I recently added a Sherbourn 5/1500A amp to my system and am now using my Yamaha RX-V995 receiver as a pre/pro. I had a buzzing problem that was related to outlets and light switches in my house using common neutrals and grounds. I resolved that issue, as detailed in another thread. buzzing...
The issue - I just added a Sherbourn 5/1500A (200x5) amplifier to my system and am now using my Yamaha RX-V995 receiver as a pre/pro. Since this addition, I have noticed that I am getting electrical interference from nearby light switches, especially those with dimmers. I can eliminate this...
I've read many threads concerning popping, buzzing and hissing sounds introduced into systems with the addition of an amplifier. I regret to say that I have joined that club.
I just added the Sherbourn 5/1500A amplifier to my system and am now using my Yamaha RX-V995 as a pre/pro. I...
I have the following equipment:
Yamaha RX-V995 Receiver (100x5)
Paradigm Monitor 9's, Main
Paradigm CC-350, Center
Paradigm Mini Monitor's, Rear
Paradigm PW-2200, Sum
OK. I was pretty much set on adding a Rotel 200x5 or Parasound 220x5 outboard amp to my system. Then someone...
Can anyone tell me the expected lifespan of a mid-fi amplifier, such as the Rotel 1095 or the Parasound 2205, etc.? I am curious as to how many years of service I could expect to receive from an amp. I know it will depend on various factors, especially frequency of use. So if you could...
I'm thinking about adding a 5 channel amp to my system and use my Yamaha RX-V995 as a pre/pro. I currently have a pair of outdoor speakers connected to the "B" speaker jacks of my receiver. Does the line signal that will be sent from the receiver to the amp apply only to the "A" speakers...
I'm a long time receiver owner, but am now curious about separates. My question may sound ignorant, so please bear with me.
Does the amp OR the preamp determine the number of channels that can be decoded and played? In other words, if I want 6.1 sound, do I need to find a six channel amp, or...
I current have a pair of Paradigm Monitor 9's sitting on each side of our 53" Sony projection TV. My wife wants to get wall pier entertainment center that adjusts to fits various size projection TV's. The problem with doing this is there won't be room for my floor speakers to sit on each side...
We are in the market for a 50"-60" RPTV. Most of what we watch is cable tv broadcasts, non digital. About 2-4 times a week we will watch DVD and/or VHS movies.
We auditioned some HDTV's from Pioneer, really nice ones, and Mitsubishi. When viewing a high def program, or even a DVD, the...