Recent content by Brenden

  1. Brenden

    What Receiver with Harman Kardon HKTS-18's

    I guess a more basic question would be whether or not I need a receiver with TrueHD? Could I spend 250 on a good quality receiver? what needs to be included with it to meet todays standards? Im looking at onkyo and sony in those price ranges.
  2. Brenden

    What Receiver with Harman Kardon HKTS-18's

    Bought the speakers from amazon for 440.00. I need to stay under 800 for the system. any ideas?
  3. Brenden

    How should the receiver connections be?

    I have the DVD set up for DD and DTS. I found a 75ohm coaxial in my box of "stuff" and the receiver automatically recognized it was a digital connection. Huge improvement from the analogue connections. This rocks!! P.S. are twisty ties ok to use when cleaning up the wire mess behind all the...
  4. Brenden

    Tying it all together

    i was reading from one of the posts here, and the person who wrote it said to stay away from twist ties. why? will this cause a problem when organizing the mess behind the TV?
  5. Brenden

    How should the receiver connections be?

    so what cable hookup do you all recomend then? i did notice on the receiver it isnt displaying digital audio, just plain pro-logic.
  6. Brenden

    Is it ok to run speaker wire between heater vent housing?

    what effect will that have? if there wont be any disturbances on the signal, then ill leave it alone the way it is. the wire coating is fairly thick.
  7. Brenden

    thoughts on leaving receiver on all the time

    will this damage the receiver? is it ok to leave it on over night if nothing is running through it at the time?
  8. Brenden

    Is it ok to run speaker wire between heater vent housing?

    Just wondering if it is ok to run speaker wire between the housing of the heater vent and the floor? Will it cause any disturbances in signal or affect the integrity of the wire?
  9. Brenden

    How should the receiver connections be?

    the rca jack (red and white plugs).
  10. Brenden

    How should the receiver connections be?

    problem. i connected my dvd audio cable to the receiver, and it wont produce sound. however, when i hooked it up to the audio 2 connections in the back, i get sound. why might this be happening? what might be wrong?
  11. Brenden

    How should the receiver connections be?

    I am finally hooking up my connections to the back of the receiver, and of course the manual has me slightly confused. I have the Kenwood HT-306 system (VR-716 receiver). I have two audio sources, TV (Wega 32") and DVD (Sony pro. scan, 5 disk). The audio jacks are all running to the receiver, do...
  12. Brenden

    Front channel layout

    and so far nothing helpful.
  13. Brenden

    Front channel layout

    I don’t have too many options for my front speaker layout. My TV is in a corner (best option I have) and I don’t have too many options for placement other than 8" from the sides of the TV. I can carry out the RF speaker about 8-12 feet from the TV, but the LF speaker will only get closer to the...
  14. Brenden

    Sub speaker wire

    i am hooking up a passive sub. what kind of shielding should i have here.
Top