Voice Coil Plot Differences

Discussion in 'Speakers & Subwoofers' started by Doug Montgomery, Nov 21, 2003.

  1. Doug Montgomery

    Joined:
    Nov 18, 2003
    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    0
    Could someone help me understand why in Bassbox Pro 6 when I select the Stryke AV15 (4 of them) and check the Dual Voice coil box (it has dual 2 ohm VC's) and wire them in series (series parallel for the drivers) for a end result of 4 ohms, the plot looks different than if I was to leave the driver as Harris Tech has it entered (Single Voice Coil with a impedence of 4 ohms?

    I have picture if I could post them. Maybe I can emaial them to someone ?


    Thanks
     
  2. Dave Milne

    Dave Milne Supporting Actor

    Joined:
    Jul 2, 2001
    Messages:
    568
    Likes Received:
    0
    Trophy Points:
    0
    Doug, you should post this in the DIY area, there are lots of gurus there that could answer this in an instant. I'm not sure, but I would guess that wiring the coils differently changes Qes which will change the plot. I have BB6 so maybe I'll give it a try when I get a chance...

    Dave
     
  3. Doug Montgomery

    Joined:
    Nov 18, 2003
    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    0
    Done..thanks
     

Share This Page