TV Emergency! MEDIC!!!! (1 Viewer)

[Lev-S]

I have a Sony KV27FS13 27" Wega and when I turned it on this morning, the "input" selection button wouldn't work on ANY of my remotes or even the TV's chassis. All that happens is the time gets displayed on the screen. I can navigate antenna based channels, but I just can't access the video inputs! Anybody have any experience with this? I have been in the service menu recently, but it was working fine for hours after some picture adjustments that I made.

 

[ChrisYK]

This might be stupid and you have probably already checked, but have you made sure the inputs aren't set to "skip" in your setup menu?

 

[Gary SI]

Lev,
You say that you have been in the service menu, you may have changed something unknowingly.
Try unpluging the set for about a minute and then plug it back in.
Anything that you have changed in the service menu will revert back to factory setting , unless you rewrote your new settings into memory.
Best of luck,
Gary

 

[Lev-S]

I reset the service mode. All is well.