SUB problems --- HELPPP (1 Viewer)

[pauld.nz]

Wow, just got my new sub this morning.

specs are --

New PB-120
2 x 8" speakers
rca in and outs
parallel input
auto on / off with signal
120 watts)

Specs on pioneer VSX-604s. ( for reference)

Continous power output : Front (1kHz THD 1% 8oams) 165 W + 165 W.

Continous power output (dolby pro logic): Front 110w + 110w center 110w rear 110w

Speakers : Jenson (DR-1205) 130 W 92 inpedance



On top of the sub there are 4 ports. A right line in + line out and a left line in + line out. The seller said that he would send me an RCA cord (the same as my CD player cord RCA) which would work fine.

I guessed that i should run either one of the plugs from the line out on either left or right to the sub out on the amp.

Is this correct ? How come the sub has left/right ports when the amp only just has one sub out ???


Also i noticed that when testing the sub at low volume, it makes nxt to no difference. R the jenson floor standings just drowing out the twin 8s ???? I even disconnected the jensons to see whither the sub was actually running !!

// Note this was at lowish volume.

I really hope this is not another mistake ----

Please advise

 

[Wayne A. Pflughaupt]

Paul,

Turn the sub up.

Regards,
Wayne A. Pflughaupt

 

[Tom Vodhanel]

Also be sure all speakers are set to SMALL in the receiver's speaker setup menu.

Tom V.
SVS