Hello!
New Member here and not sure the best place to post this question.
I’ve recently swapped out an Onkyo TX-NR1010 AVR in my 7.2 home theatre system to a Marantz SR7012. After hookup and calibration I’m hearing audible (and irritating) buzz through all 7 speakers. I went though the process of disconnecting inputs one by one to determine th source and I found that the buzz stops when I disconnect the two rca connections from the receivers pre subwoofer outs. The two sub lines run from the AVR to a Bheringer Feedback Destroyer Pro/EQ and then to a Bheringer EuroPower 4000 amp.
Any thoughts on how to reslve the speaker buzz as the two Danley DTS subs are critical to my setup. I didn’t have this issue with the prior AVR.
New Member here and not sure the best place to post this question.
I’ve recently swapped out an Onkyo TX-NR1010 AVR in my 7.2 home theatre system to a Marantz SR7012. After hookup and calibration I’m hearing audible (and irritating) buzz through all 7 speakers. I went though the process of disconnecting inputs one by one to determine th source and I found that the buzz stops when I disconnect the two rca connections from the receivers pre subwoofer outs. The two sub lines run from the AVR to a Bheringer Feedback Destroyer Pro/EQ and then to a Bheringer EuroPower 4000 amp.
Any thoughts on how to reslve the speaker buzz as the two Danley DTS subs are critical to my setup. I didn’t have this issue with the prior AVR.
