rear surrounds dont work anymore

Discussion in 'AV Receivers' started by jeff garver, Jan 4, 2005.

  1. jeff garver

    jeff garver Auditioning

    Joined:
    Nov 22, 2004
    Messages:
    9
    Likes Received:
    0
    I just picked up a Pioneer 1014, hooked it up and it was working fine until I decided to check out its MCACC feature now the rear surrounds dont work. Is there anyway to get the reciever to go back to its factory defaults?
     
  2. brentl

    brentl Cinematographer

    Joined:
    May 7, 1999
    Messages:
    2,921
    Likes Received:
    1
    Go into the menu system and the manual speaker setup, or even bring up manual MCACC, it should tell which speakers are operating and allow you to adjust them.

    Weird that the 1014 would do that though.

    Brent
     

Share This Page