RCA Jack

Discussion in 'Beginners, General Questions' started by EdQ, Apr 28, 2003.

  1. EdQ

    EdQ Stunt Coordinator

    Joined:
    Feb 27, 2000
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    0
    Not sure where to post this. But I have a Energy Microstar 12.1. The RCA cable that plugs into the female jack on the sub broke off in the jack. The pin is still inside. Any idea where I can get a replacement jack??

    [​IMG]
     
  2. Rick_Brown

    Rick_Brown Second Unit

    Joined:
    Oct 25, 2001
    Messages:
    449
    Likes Received:
    0
    Trophy Points:
    0
    Can you get the piece out of the jack using needle nose pliers? Take the part showed in the pic to Radio Shack. They should be able to give a replacement and advice. If it were me I'd just buy a new cable rather than repair the old one.
     
  3. EdQ

    EdQ Stunt Coordinator

    Joined:
    Feb 27, 2000
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    0
    I plan on replacing the broke adapter. But I don't know how to get that pin out. Its a tight fit. If I can find an exact replacement, I will do that. I also emailed Energy.
     
  4. Rick_Brown

    Rick_Brown Second Unit

    Joined:
    Oct 25, 2001
    Messages:
    449
    Likes Received:
    0
    Trophy Points:
    0
    You might be able to open up the Energy and then push out the broken connector from the other side of the panel, but I'd wait for Energy's advice to be safe.
     

Share This Page