Problem integrating Denon AVR-4806 and Mitsubishi HC-900 projector

Discussion in 'AV Receivers' started by Paul Campbell, Aug 2, 2005.

  1. Paul Campbell

    Joined:
    Feb 20, 2002
    Messages:
    39
    Likes Received:
    0
    Trophy Points:
    0
    I don't know if this is the appropriate forum for this question, but it can't hurt to try.

    I am connecting a Denon AVR-4806 using the HDMI output into a Mits HC-900 with an HDMI to DVI converter. The picture, whether I am looking at a DVD menu or a blank screen with just the Denon onscreen menu, looks great, as far as the left two-thirds are concerned, but the right third of the screen is a repeat of the left third. I have tried every setting change I can find. Normally I would have defaulted to the assumption of faulty equipment, but this is my first install with an upconverted HDMI out, and I can't help but wonder if the two just aren't communicating properly. Any suggestions?
     
  2. Chris Bruner

    Chris Bruner Auditioning

    Joined:
    Jul 3, 2005
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    0
    OK, THE NEW DENON IS A MOTHER OF COMPLEXITY SO HERE GOES-
    YOU NEED TO CHANGE TO THE COMPONENT OUTPUT TEMPORARILY, WITH THE GOAL TO ACCESS THE DENONS VIDEO INPUT- HDMI OUTPUT MENU 4-4, SET UP MENU WITHOUT IT BEING DISTORTED SO AS TO CHANGE THE COLOR SPACE TO RGB . TRY TURNING THE UPCONVERSION OFF. DOES THE PROJECTOR SHOW THE SIGNALS SCAN RATE?
     

Share This Page