Need advice on Tempest sub

Discussion in 'Archived Threads 2001-2004' started by TimForman, Dec 13, 2002.

  1. TimForman

    TimForman Supporting Actor

    Joined:
    Dec 4, 2002
    Messages:
    847
    Likes Received:
    0
    This is my first sub project. I've chosen to build the Mid Q design from Adire for the Tempest. It'll be powered by an external amp and the crossover will be handled by my receiver. Along with the driver I picked up the Sub S kit. Am I missing something? I've seen some talk on band pass filters and other electronics but I'm not sure if I need anything else.
     
  2. Pete Mazz

    Pete Mazz Supporting Actor

    Joined:
    May 17, 2000
    Messages:
    761
    Likes Received:
    0
    Input terminals, polyfill or equiv., speaker wire, foam weatherstrip tape to seal driver.

    Other electronics may be needed after you build, test, position the sub in your room.

    Pete
     

Share This Page