I am finalizing the build of my second DIY project, and I am ready to mount the crossovers in my LCC. My other project (Adire 281 towers), came with hardware and I believe a designated spot to mount the crossovers, so my job was easy. My current project (Exodus LCR) didn't seem to come with either of those, so I am trying to get clarification on how to mount the crossovers. After reading around this morning, it looks like people tend to hot glue the peg board straight to the enclosure. Does anyone have any pictures of this? If you don't screw the board down, how do you keep it in place while the glue dries? Did you just put a little glue in each corner of the board, or does it take a significant amount? I have my crossovers soldered and ready to go, and I just happen to have a glue gun in the next room ready and willing. Thanks!