Juan Pegler
Auditioning
- Joined
- Aug 14, 2013
- Messages
- 10
Hi
I would really appreciate some help on this. I have searched everywhere and got no answer.
The Set-up:
Samsung HW-E5500 AV receiver. (Using 2 x HDMI in.And 1 HDMI out to the TV.)
Samsung BD-D5500 3D SMART Blu-ray Player. (Using the HDMI output to AV Receiver)
JVC LT-50N810 (Using the HDMI from Av receiver)
The Problem:
I just purchased the TV and when connected this is the problem. Note: Old TV never did this (also using HDMI)
When I put the tv to the HDMI connected from the AV receiver in blinks on and off every second or so. also when its on the that second the screen is Pink.
But when I connect the same sound system VIA AV cables I can look at it and change settings. The sound system only gives me 3 settings I can change under the "Display" settings: SYSTEM (pal or ntsc) Screen mode (TV or monitor, when monitor is selected the pink goes away on the HDMI but it still blinks)
Now here is the confusing part. When I plug the 3D player in directly the TV shows it 100% but then I cant have my sound via the sound system because the tv only has AV out. not HDMI out.
I tried to explain this as well as i can. hope its enough info for someone to give me some advice.
I have searched and found resets via the Service menu. (I dont thing this is my rob because the BD works via HDMI) but i was grabbing at straws lol. but that reset does not work on my tv because my remote does not have some of the buttons the guides described.
Thanks in advance for any answers.
I would really appreciate some help on this. I have searched everywhere and got no answer.
The Set-up:
Samsung HW-E5500 AV receiver. (Using 2 x HDMI in.And 1 HDMI out to the TV.)
Samsung BD-D5500 3D SMART Blu-ray Player. (Using the HDMI output to AV Receiver)
JVC LT-50N810 (Using the HDMI from Av receiver)
The Problem:
I just purchased the TV and when connected this is the problem. Note: Old TV never did this (also using HDMI)
When I put the tv to the HDMI connected from the AV receiver in blinks on and off every second or so. also when its on the that second the screen is Pink.
But when I connect the same sound system VIA AV cables I can look at it and change settings. The sound system only gives me 3 settings I can change under the "Display" settings: SYSTEM (pal or ntsc) Screen mode (TV or monitor, when monitor is selected the pink goes away on the HDMI but it still blinks)
Now here is the confusing part. When I plug the 3D player in directly the TV shows it 100% but then I cant have my sound via the sound system because the tv only has AV out. not HDMI out.
I tried to explain this as well as i can. hope its enough info for someone to give me some advice.
I have searched and found resets via the Service menu. (I dont thing this is my rob because the BD works via HDMI) but i was grabbing at straws lol. but that reset does not work on my tv because my remote does not have some of the buttons the guides described.
Thanks in advance for any answers.