Jedd
Second Unit
- Joined
- Feb 5, 2002
- Messages
- 298
I just put my tube, driver and amp together and found one good and one bad thing.
good one: cables from the amp are long enough to reach the driver
bad one: the "amp connectors" doesn't fit into the driver's terminal
So, what would you recommend, cut the connectors off and stick naked amp wires into the terminal or somehow solder/plug them to the cables paralleling terminals on the driver? (like remove isolation from the paralleling cable somewhere in the middle and stick amp cable to that place)
Any other ways around?
good one: cables from the amp are long enough to reach the driver
bad one: the "amp connectors" doesn't fit into the driver's terminal
So, what would you recommend, cut the connectors off and stick naked amp wires into the terminal or somehow solder/plug them to the cables paralleling terminals on the driver? (like remove isolation from the paralleling cable somewhere in the middle and stick amp cable to that place)
Any other ways around?