Hitachi 51S700 - Convergence will not save - Please Help!

Discussion in 'Displays' started by JohnKings, Sep 24, 2003.

  1. JohnKings

    JohnKings Stunt Coordinator

    Joined:
    Dec 2, 2001
    Messages:
    174
    Likes Received:
    0
    Hello:

    I just got my new Hitachi 51S700 last week. Over the past few days I have been working on my geometry and have noticed that the service level manual convergence seems to drift a little each time I go back to look at it. I am giving the TV 20 minutes to warm up, but it seems, especially at the bottom and top, that the convergence loosens. Should I be giving the TV a little longer to warm up? Should I run magic focus before or after configuring in DCAM mode? This is just frustrating because when I think I have my convergence very good, I go back to check and the edges are out of alignment again. TIA for any assistance.

    John
     
  2. Paul Slund

    Paul Slund Extra

    Joined:
    Sep 16, 2003
    Messages:
    17
    Likes Received:
    0
    I seem to be having the same problem with my Toshiba 57HX83. I've been told it takes about 3 months to break in a new RPT, but I don't know if that's what's affecting it. I'm re-converging it once a week or so.
     

Share This Page