Help! Dead Barco Data 600

Discussion in 'Archived Threads 2001-2004' started by al chaney, Jun 30, 2002.

  1. al chaney

    al chaney Extra

    Joined:
    Jul 31, 2000
    Messages:
    23
    Likes Received:
    0
    [​IMG] I need help with a dead projector. the unit will not power up , no lights, nothing. Any help apprceiated.
    al
     
  2. arbey

    arbey Auditioning

    Joined:
    May 20, 2002
    Messages:
    1
    Likes Received:
    0
    Try to see if all fuses are OK, they are located on the second board on your right standing behind the unit ground setup. Change the N/Sboard, the one on the left. Check if the power supply is set on the right voltage. Do you have the little magic box, the controll switcher that used to be plugged in the back?
    hope this helps a bit...
     
  3. derek

    derek Second Unit

    Joined:
    Dec 20, 1998
    Messages:
    494
    Likes Received:
    0
    There are quite a few BD600 experts on avsforum.com CRT forum. [​IMG]
     

Share This Page