f1nuts
Stunt Coordinator
- Joined
- May 4, 2007
- Messages
- 63
- Real Name
- jason cottee
i had posted this in the speakers section, but no reply .
have a fixed crossover htib receiver, about 2 yrs old 6.1 .
there is no menu setting for speakers large/small either.
so assume if selecting yes for subwoofer, all the speakers automatically are assumed small by the receiver ?
as there is no setting for crossover thats selectable on receiver
i should then just crank up the subwoofer crossover to it max or at least 20hz more than the receivers fixd crossover ( which i beleive is 90hz)
or do i set the sub somewere around what my old front l/r polk monitor 10's lowest cut off point is ?
specs for these fronts are :
Overall Frequency Response 25Hz - 25kHz
Lower -3dB Limit 37Hz
Upper -3dB Limit 25kHz
Nominal Impedance 8 ohms
Recommended Amplifier Power 20-250 w/channel
Efficiency 89 dB
from above what would be the lowest point the polks go down to ??
a simple yes or no would be great, as i hate sitting here thinking it could possibly be wrong !
thanks
have a fixed crossover htib receiver, about 2 yrs old 6.1 .
there is no menu setting for speakers large/small either.
so assume if selecting yes for subwoofer, all the speakers automatically are assumed small by the receiver ?
as there is no setting for crossover thats selectable on receiver
i should then just crank up the subwoofer crossover to it max or at least 20hz more than the receivers fixd crossover ( which i beleive is 90hz)
or do i set the sub somewere around what my old front l/r polk monitor 10's lowest cut off point is ?
specs for these fronts are :
Overall Frequency Response 25Hz - 25kHz
Lower -3dB Limit 37Hz
Upper -3dB Limit 25kHz
Nominal Impedance 8 ohms
Recommended Amplifier Power 20-250 w/channel
Efficiency 89 dB
from above what would be the lowest point the polks go down to ??
a simple yes or no would be great, as i hate sitting here thinking it could possibly be wrong !
thanks