What's new

grinding down a bucking magnet need help quick (1 Viewer)

Jason-Pro

Stunt Coordinator
Joined
May 20, 2002
Messages
146
i have some stryke 7" drivers and the bucking magnets hit the part in the middle on the back that goes up a little so its not sitting onto the back of the speaker.
if i use a dremel to grind it the motor will get wrecked very quickly cause of the shavings.
if i use a file that will screw up the magnet correct?
and sandpaper? would take about 20 years?
please help me asap gonna be doing it in a couple hours or now :)
 

Jason-Pro

Stunt Coordinator
Joined
May 20, 2002
Messages
146
he told me just to use a file but he didnt know if it would wreck the magnet or not
i only live 25 mins from him i was up there last week to get my speakers. :)
hes a good guy
 

Users who are viewing this thread

Top