DScaler 4.1.6 and Radeon 9000 Pro

Discussion in 'Computers' started by Kris Niesen, May 3, 2003.

  1. Kris Niesen

    Kris Niesen Auditioning

    Mar 9, 2003
    Likes Received:
    Trophy Points:
    I'll use DScaler 4.1.6 for a while and it gives much better video than the software included with the capture card.

    But there is a strange thing. Maybe someone knows what I can do about it.


    * AMD Athlon XP 2000+ processor running at 1800 Mhz
    * MSI KT3 Ultra 2 motherboard (MS-6380E)
    * Hauppauge WinTV PCI capture card
    * Hercules Prophet 3D 9000 Pro 128 Mb (ATI Radeon chipset) videocard
    * 512 MB Ram

    I use the temporal noise filter set to 50.
    I use auto pulldown, auto video detection and judder termination

    Besides this configuration (I have tried many settings in DScaler on and off) I always can detect the following artifact:

    When there is a horizontal movement from camera viewpoint (left to right or otherwise - f.e. football match) the TV image picture is too slow and blurry. No natural movement in my opinion. With vertical movement (f.e. at the end of a movie) it's OK.

    What is the cause?

    * A faulty setting in DScaler
    * A faulty setting in my control panel for my videocard
    * just a bad video card
    * bad capture card
    * to slow processor
    * normal behavior
    * something else

    I like to here some comment here.

    Thanks already
  2. Raymond G

    Raymond G Agent

    May 20, 2000
    Likes Received:
    Trophy Points:
    I would suggest you try this site www.avsforum.com

    I have just about the same type system you have, but do not have this problem.

Share This Page