Doing 64-pt convergence without resetting 9-pt settings? (1 Viewer)

[Jason_H]

I have a Toshiba 56H80, which is their 2001 model. As you probably know, the Design mode is inaccessible on these models. All of the directions on the Keohi HDTV site mention going into Design mode to reset the 9-pt convergence settings before doing a full 64-pt service convergence. Is there any way around this? Would I still get the benefit of the 64-pt convergence if I don't reset these settings?

 

[Kevin Red]

I asked that same question regarding my 65HX81. It was explained that it is not necessary to reset the 9pt. before doing the 56pt. I did not reset mine before doing the 56pt. and it made no difference. The 56pt. worked perfectly.

 

[Jason_H]

Okay, I will give it a go. Thanks!