1. Sign-up to become a member, and most of the ads you see will disappear. It only takes 30 seconds to sign up, so join the discussion today!
    Dismiss Notice

DIY Illuminated Poster Frame

Discussion in 'Archived Threads 2001-2004' started by Darren Mortensen, Nov 16, 2002.

  1. Darren Mortensen

    Darren Mortensen Stunt Coordinator

    Joined:
    Jul 26, 2001
    Messages:
    232
    Likes Received:
    0
    Trophy Points:
    0
  2. Bryan Michael

    Bryan Michael Supporting Actor

    Joined:
    Mar 2, 2002
    Messages:
    564
    Likes Received:
    0
    Trophy Points:
    0
    my fraim is similar but different i went with a liw profile 1x2 and put a half round on it mitered the corners and painted it black and my fraim holds bothe pieces of plexi
     
  3. Darren Mortensen

    Darren Mortensen Stunt Coordinator

    Joined:
    Jul 26, 2001
    Messages:
    232
    Likes Received:
    0
    Trophy Points:
    0
    What are you using for illumination?
     
  4. Bryan Michael

    Bryan Michael Supporting Actor

    Joined:
    Mar 2, 2002
    Messages:
    564
    Likes Received:
    0
    Trophy Points:
    0
    i used florsents but my costs were at least half all i did was buld a box out of 1x4 slect pine and put a pice of thin plywood in a slot i roughted around the back then glue and it in there and it is solid. then i atached the mounts and i used 2 transformers with my setup i got 2 cheap shop lites cheaper than the 1 ballast so i used them
     

Share This Page