Hello, I finally broke down and purchased a Sony BRAVIA KDL32EX720. Thinking of the future (3D), but not concerned with 3D at present. the input/output specs on this are: Inputs HDMI: 4 (1 Side/3 Rear) Component Video (Y/PB/PR): 1 (Rear) Composite Video: 2 (1 Rear/1 Hybrid) USB 2.0 Ports: 2 (Side) RF Connection: 1 (Rear) Analog Audio Input: 2 (2 Rear) PC Input: DSub 1(Side), Mini 1(Rear) Ethernet 1 (Rear) Outputs Digital Audio Output: 1 (Rear) Analog Audio Output: 1 (Side/Hybrid) Amp is a Yamaha RX-V1700, equiped with 2 HDMI inputs (only 1.3a so 3D is suspect anyway) and one HDMI output. Also plenty of optical digital audio out and in plugs for many devices. Have Cablebox with HDMI out, DVD with HDMI out, old VCR with analog out,and then a few analog devices that do not need monitor. I was planning on connecting Cablebox and DVD to the 2 HDMI inputs on the Yamaha, and then using the 1 HDMI output to go from amp to TV The EX720 can upsample the VCR signal, so no problem there. The issue is what to do about Web TV! I probably haven't thought enough about it, and I'm sure it's a simple answer, but I am not exactly sure how to configure this setup. Again, the RX-V1700 only has 2 HDMI inputs, so I can't run HDMI from the TV back to the Amp for a complete loop back to the TV if I have the 2 HDMI inputs filled with Cablebox and DVD. Has anyone had this kind of setup work in the past? Perhaps changing what goes into the Amp and what goes into the TV would provide a better configuration, but I am stuck at this point. Any suggestions would be most appreciated. Thanks to you all.