Belkin PF60 and Pioneer 1019 12v trigger (1 Viewer)

[eurovw89]

I am trying to send a 12v trigger from my receiver to my power center to turn it on. My Pioneer 1019 has: IR - IN & OUT Control - IN & OUT Belkin PF 60 has: DC IN I tried connecting a 3.5m mono cable from the "IR OUT" and tried from "CONTROL OUT" from my receiver to the "DC IN" on the Belkin....and nothing. Does anyone have anything of these two and tried? Thanks, Jeff

 

[Charles Smith]

Different components, but this might be of some help:

My Pioneer 21TXH controls two amps. Connections are from the 12V trigger outs on the Pioneer to the 12V trigger in on each amp. I also had to go into the Pioneer's setup to enable the use of the trigger -- I think it was in each source setting.