chaostoday
Grip
- Joined
- Apr 23, 2013
- Messages
- 20
- Real Name
- Jason
I'm going to make some balanced cables for my EMO amp to preamp with some Belden 1800F I have. I purchased some Neutrik XX series XLR's that I have used in the past with other balanced cable. I noticed that the belden has Positive, negative and ground along with the braid. Not used to this.
Do I combine the braid and the ground wire on pin 1? Normally on my other cables I run the braid to pin 1 and the other two wires to pin 2 and 3.
Any thoughts?
Do I combine the braid and the ground wire on pin 1? Normally on my other cables I run the braid to pin 1 and the other two wires to pin 2 and 3.
Any thoughts?