AVR 320 setup help

Discussion in 'Archived Threads 2001-2004' started by mike_doyle, Dec 5, 2002.

  1. mike_doyle

    mike_doyle Agent

    Joined:
    Nov 22, 2002
    Messages:
    34
    Likes Received:
    0
    OK, here are my speakers, All Paradigm:

    Speaker..............Response ...........LFE (DIN)......Efficiency
    ADP 170 Rear____90Hz – 20KHz_____65 Hz_________90 dB

    CC 350Center___70Hz – 20KHz____57 Hz__________93 dB

    Monitor 3 front___58Hz – 20KHz____38 Hz__________91 dB


    I was thinking of setting all speakers to large and setting the X-over to 60 Hz. then I started wondering if i should set the center and surrounds to small and the X-over to 80 Hz?

    Any opinions suggestions?

    My room is about 10 by 15 ft.

    Thanks
     
  2. Rick_FL

    Rick_FL Stunt Coordinator

    Joined:
    Dec 4, 2002
    Messages:
    171
    Likes Received:
    0
    I'd set them all to large, and x-over freq to 60hz, and use lfe+l/r. anything 60hz and under will get played by both fronts and the sub. Experiment a little. you may find you like another combination better
     
  3. mike_doyle

    mike_doyle Agent

    Joined:
    Nov 22, 2002
    Messages:
    34
    Likes Received:
    0
    I was thinking about the LFE = L/R

    Right now I am running 2 Klipsch 15" subs off of a 100w x 2 amp. So i get tons of Low Bass...
     

Share This Page