Aktis RC-8000 System call

Discussion in 'Archived Threads 2001-2004' started by Dave Pobuda, Jan 7, 2003.

  1. Dave Pobuda

    Dave Pobuda Stunt Coordinator

    Joined:
    Dec 25, 1999
    Messages:
    82
    Likes Received:
    0
    I found a code that allows me to have direct access to the different inputs on my Mits WT-46809 TV by only using one button on my remote. I learned the command to a button on my Aktis RC-8000 and it works great! One button access to the DVD input. I've tried putting the command in to the system call,everything works except for this button. Any help would be appreciated.

    Thanks
    Dave
     
  2. Mike OConnell

    Mike OConnell Second Unit

    Joined:
    Jun 14, 1999
    Messages:
    489
    Likes Received:
    0
    Location:
    Overland Park KS
    Real Name:
    Mike
    Dave:

    When I programmed my Aktis (have since replaced with a Pronto), I also had direct access codes for my Mitsubishi inputs that I learned into my Aktis.

    They worked fine when just pushing the button, but in the sys-call they did not. The problem was with the duration of the IR signal, it was too short as a single command, so I repeated the command in the sys-call three or four times (I think - I kept adding until it worked and then added an extra) and this kept the duration long enough to change the input.

    Good luck!
    Mike
     

Share This Page