What's new

7 channel A/B switch (1 Viewer)

Status
Not open for further replies.

Jared D

Auditioning
Joined
Aug 4, 2005
Messages
7
i would like to know how to power a set of 7 speakers with one of two amps. one amp is the pioneer 56txi receiver (110x7), the other is a similar model. maybe i could just run two sets of speaker wire to each speaker. i think i heard that thats a bad idea though. because if both receivers were on at the same time for some stupid reason, things would get damaged. maybe what i need is a 7 channel A/B switch. preferably IR controllable. i looked at xantech and speakercraft. i dont think that either company has what im looking for...

any suggestions would be greatly appreciated.

Jared
 

Shawn Solar

Supporting Actor
Joined
May 12, 2001
Messages
763
I've used a 6 channel a/b switch. I powered them with a pioneer 1014 tx or something. I used the front on A and the rear channels on B. You could then also then use the side surround channels to power the most poer hungary zone or fartheset run for all 7. that would be 3 pairs/ 1 input and one input for one output. I think it was an OMAGE brand speaker selector.
 
Status
Not open for further replies.

Users who are viewing this thread

Latest Articles

Forum statistics

Threads
356,810
Messages
5,123,543
Members
144,184
Latest member
H-508
Recent bookmarks
0
Top