1-Ohm setup (1 Viewer)

[Scott L]

Finally got the rest of the hardware in, never did anything leess than 4-ohm before and I wanna make sure I connect everything right:



HiFonics Brutus BX1000D > 1 wire to the terminal cup > 2 wires from here: 1 set of postive and negative to each voice coil. Sound about right?

 

[Sean^M]

IF the amp is one Ohm stable, that looks fine.
bridged I take it.

 

[Scott L]

Yea that's the way it says to do it in the amp manual but the picture they show of the sub doesn't look like a DVC. Just wanted to make sure I won't make anything blow up when I finally power the amp.