Search results

Problem finally diagnosed.... the RX-A2080 works when i move it towards to the projector and i attach it with a short 3m HDMI-cable. The cable that is in the wall is 15m long, category 2 - 4K capable cable. The RX-A3010, the RX-V671 and the Raspberry Pi work perfectly with that cable. But it...

factory reset does not make a difference either

I tried to set the resolution to AUTO and to 1080p in the receiver, both don't work. Also remarkable is that, when i attach both projector and an LCD monitor to HDMI OUT 1 and 2 of the receiver, i don't even get an image on the LCD screen. When only the monitor is attached and not the projector...

Another test i ran tonight: i'm getting the same thing (no picture on the Panasonic projector) with an RX-A780. This same RX-A780 plays perfectly on a Panasonic 50" plasma TV. So is this a problem with all models of the aventage xx80 series? I you wonder were i get all these receivers - the...

Hello Edwin-S, the test monitor was a computer monitor 1920x1080 resolution. Thanks for your input, I'll run some more tests tonight... kind regards, Geert

Tonight i tried to place a Yamaha RX-V671 between the Pi and the beamer. Also this receiver worked as soon as i had connected everything, no need for any settings change. This RX-A2080 makes me go crazy....

Hello Edwin-S, I have not checked the modes yet. So i guess they are set default (Mode 1 ?). If i understand it right the two modes refer to the DTS-standard used? The peculiar thing is that everything worked fine with the RX-A3010, and that also the raspberry pi outputs perfectly when i...

Hello, JohnRice, yes, thank you for your kind reply. I do fully understand that modern receivers are not just plug and play. I did do a large part of the setup already, mainly just YPAO calibration still to be done, and as stated above, i ruled out the HDMI OUT as a possible defective part...

Hello there, This is my very first post on the forum and i hope somebody can shed a light on this puzzle. I recently switched from an RX-A3010 to an RX-A2080 for our home theatre setup. We are using a Panasonic PT-AT6000E projector and a Raspberry Pi with Kodi as a source. All cables are HDMI...