Search results

I actually just added that to my amazon wish list so that I could find it later- I guess using the single controls in the wall downstream of the 2x6 matrix would be redundant?

I have the wires routed down the walls and in boxes for them but haven't actually installed them yet. What do you think about something like this: http://www.amazon.com/AudioSource-AE100VC-Impedance-Matching-Control/dp/B003H3C94W

I guess I assumed it was going to be a lot more complicated- When it comes to AVR, I'M stuck in the stone age, to be honest. I just knew that if I tried to run 7 extension cabs to my bass amp, there would be smoke sooner than later lol. So- about the volume controls: Do you think I should nix...

So, this is probably a dumb question but- that receiver pushes 135 watts PER channel?

I put volume controls in for virtually one reason, and one reason only- to turn the sound down/off if needed, without having to go to a central location and switch the speaker pair off. If my wife's phone rings while she's in the kitchen, or if I'm listening on the back porch and she's listening...

Just the kitchen- I can change that really easily, however.

Hi, I'm Joey and I'm new. I posted a thread in another forum and figured it would be rude to ask for help without introducing myself! I'm a musician but don't know much about home theater or home audio setup! I just built a house and am finally to the point where I can start tinkering with...

I have wire ran for the following: one speaker pair in my kitchen (I ran the wire for an in-series config but that can be changed), one speaker pair in my family room, and two pairs on my back porch (it's long and narrow and had planned on an alternating L,R,L,R config). I have the kitchen and...