Search results

I have the Yamaha 1400 the 2400s slightly smaller brother. Mine has the zone 2 and 3 lights on also. I have turned them off a few times but they come back on next time the reciever is powered up. I don't have anything connected to the zone 2 and 3 outputs so I have no idea if it is outputing...

They are not any special type of speaker. I just used a small set of bookshelf speakers. In my case since the rest of my system were AAD speakers I just got a set of C100i speakers. They are not run very hard. The amp feeds to them things that are behind the sound stage to them. I am not sure...

I'd suggest using a little trick I learn't years ago when I ran a mobile disco. To prevent the woofers from flopping about and possibly polling during transport, short out the input terminals of the speaker. This damps the speaker movement very effectively. (Try moving the cone with and without...

I have the Yamaha 1400 receiver and for the first 3-4 months didn't have presence speakers. I used a lot of the DSP modes and if they were trying to give the illusion of having presence speakers they were not doing a very good job of it. Having the actual speakers is way better.

I assume you have some presence speakers hooked up to these terminals. They should be above and to the outside and a bit behind the main speakers widening the sound field (the top corners of the room are good). There are a couple of things to watch out for. First the system has to know they are...