Search results

I normally don't chime in on vendor comments unless they are really good or really bad . In the case of best buy I would have to say they follow the later. My last experience with them was last week when my cousin asked me to go computer shopping with him. He wanted a "in the box"...

Why stay away from overstock.com? I was about to order something from them (not dvd's). Curious about your experience there.

hmmm. cannot posts links yet. Try this one. www(dot)x2vga(dot)com hope that is not against the rules. :frowning:

IMO, calibration fees should be a flat rate. Installation fees could arguably be hourly rates, but IME it is better to get a flat service install quote. That is what the quotes are for, so you can have a total estimate. As far as hanging the projector. It is relatively simple. Especially...

Nice setup. The time you have taken to make a clean setup definately shows in the details. Great looking movie area. Setting up the HT is half the fun!

I think the offset that he is referring too is actually the lens offset of the projector. If you have not already found your answer, you will need to center the lens and not the mount and/or the projector. The lens is not in the center of the projector so you will need to mount it to one side...

I want to avoid running speaker wires through the wall (double insulated/ with double cross bracing). I have onkyo bookshelf rear speakers (3) wich I have screwed keyhole hanging brackets on. I purchased 3 ceiling mounts. Can I just run the speaker wires for the rears from the receiver in the...

wow... no replies. There has gotta be people with ceiling mount speakers out there ! :frowning:

I want to avoid running speaker wires through the wall (double insulated/ with double cross bracing). I have onkyo bookshelf rear speakers (3) wich I have screwed keyhole hanging brackets on. I purchased 3 ceiling mounts. Can I just run the speaker wires for the rears from the receiver in the...

I have an x1 projector and a sony DAVFC7 receiver with built in DVD. I want to hook up an x-box ,a datellite receiver and a computer to my Infocus X1 pj, but cannot figure out how to best do this with the inputs/outputs availible. I am running 30 ft away from the receiver to the projector...