In your burning software, it should give an option to burn an audio cd (not a data cd), then it will automatically convert the mp3 files to cd audio tracks.
Steve: I have the previous model, the RCA RT2500. The passive sub output has the crossover built into the reciever, so hooking up the sub to a full spectrum output is not the best idea. If the sub you have is still the model with dual 5" drivers, you will really notice the difference with a...
Check page 23 of the manual. There are several settings you need to check. Set the front speakers to NML/THX, if you set them to LARGE then you also need to set SW RE-MIX to ON. Make sure the RCA cable is connected to the single subwoofer connector below the center channel connector, NOT to...
I realize the power ratings on low end models like this are overly optimistic, but I dont have the original subwoofer to look at for impedance values. The specs say the sub output is 200w at 3 Ohms, so based on that a 6 Ohm driver at 100w should be ok. That is the same as my bookshelf...
I need to replace the original subwoofer that came with the RCA RT2500 theatre in a box system. It was a small box, less than a cubic foot, with dual 5" drivers. My guess is the drivers were each 6 Ohm wired in parallel. The subwoofer amp built into the receiver is rated for 200w into 3 Ohms...
Thanks guys :) Tried it out and it does seem to be low-pass filtered in some way. I was pleasantly surprised by the bass output of my bookshelf speakers too. And thanks to the thread on test tones, I can burn a test cd to see what the corner frequency is on the output. So it seems to build a...
My RCA RT2500 receiver has a builtin amp for the passive sub. I would like to know if the output is already low-pass filtered, or if the crossover is built into the passive sub enclosure. Im thinking I can just connect one of my bookshelf speakers (100w,6 Ohm) to the amplified sub output (200w...
On my receiver (RCA RT2500) each of 6 speakers can be set to large/small/none. Right now I have no center channel speaker. If I set it to None, will the center channel be redirected to the front left/right channels? My 10yr old ProLogic system has a phantom center setting to do this, but I see...
Im new here to the forums and to HT in general, so please forgive any obvious questions :) I just got a second hand entry level receiver (RCA RT2500) and now need a sub. This receiver has both a line-level RCA sub output and a built-in dedicated subwoofer amp with spring clip connectors. So I...
There is a "Dolby Digital 3" mode, that uses front speakers to generate a virtual rear surround effect. Could that be it? Saw this on the list of modes for the RCA RT2500.