Very helpful. Thanks. Is there any point to using a "line cleanser", if I have the term correct? Something that makes the current more uniform. Could that have been the problem, or am I best spending my time looking elsewhere? BRM
I have tried to reset it without any speakers attached, and it still failed to restart. As a result, I shipped the receiver back today. Any suggestions, besides "turn it down", to prevent this from happening again? Other tests that I should run with the new receiver to see if there is something...
I am running Polk Lsi's, front, center, and sides, which are nominally 4 ohms. I am have an SVS PCi sub. I was standing in front of the screen, and turning it up with the remote, so I have no idea on quantifying "how loud". BRM
I am having the same problem. Had the unit cranked up for the first time tonight, having watched a number of movies at lower volume in the past. System cut out, and getting the flashing light of the protection circuit up front. Have tried to give it time, and have tried to reset "factory...
I appreciate your suggestions. There is inadequate room to do "countersink" the speakers. I am told that the Polk inwalls are kinda weak compared to similarly-priced inwalls from other manufacturers. Now, it may be that it still is the best option, given the desire to "match", but I have...
In a new theater area, where we will be watching movies from DVD and some sports shows, some HD-source, some not, having a tough time deciding between the 2 listed above. Had my heart set on the Mits 73909 until a dealer mentioned the other day that, in his opinion, analog will look much better...
For a new home theater installation, I have found I really enjoy the new Polks. This is going to be a room primarily for movies, and some sporting events, and is not a "dedicated room". Unfortunately, I need to do the rear channel speakers as inwalls, and am unclear as to how to determine which...