Search results

Today I sold 1 of my DDRC88Ms, and my Yamaha cxa5100 AVP, and ordered a Marantz av8805a...now I can have more channels and also Auro3d.

You could always make a pair of grills if you want to hide te damage inside the horns.

Speaker progress is delayed a bit. I stopped it because a friend was supposed to do some metalwork on my cases... I figured while the amps were down is the perfect time to reconfig the amps. Well it has been 3 weeks now, and some parts I ordered and paid for were cancelled by the seller for the...

My new build is the Negatron...old system was torn down and mostly sold. New setup is in Mexico and started in 2018.

I hope to have at least one pair of the MINI MEHs completed (at least the horn part), by the end of January...as I have 2 clamping molds ready. I also am building a full size MEH out of wood...just like the MINI but full size. In addition... I have one k402 horn left and will be building an...

New woofers for the MEHs have arrived and they dig deeper than the kappa 15Cs do. I also did some sanding on my MEH plaques for the speakers. Also some measurements.

Here is mine...still some work to do on it, but it is getting close to where I want it.

Today a friend of mine helped me get our valances completed.

I will be doing some upgrading over the next few months... Ordered: Minidsp ddrc88m (never should have sold the 2 I had in my last HT) 2 Pass ACA stereo/mono amps Diy projects: 2 2' x 2' MEHs modeled from the small side of my k402 MEHs. These will use the same drivers, but the horn will be...

Just got the 2nd cabinet back from my carpenter.

Fired up the new amp tonight and it sounds great. Tomorrow I will make a couple of new power cables, and 2 more speakon cables. Then I will use it until I get around to setting up the LEDs.

I used to go quite often to Theaters, but in the last 20 years I changed to once or twice a year. For me I like to have the best experience possible if I am going to pay the price they want, and the experience over the last 10 years has not been good at all. The theaters have went to not framing...

Some pics of my amp that we are working on... The amp is made with 3 asx50, and 3 asx125 Icepower amp modules. All are being setup for BTL mode (balanced). The smaller amps will be for the front 3 channel k402MEH horns, and the larger amp modules qill be for the dual 15" woofers in each speaker...

I am currenly working on building a new Home Theater in Mexico. This one will not be a dedicated HT, but a HT in our living room. Currently I have the following equipment: AUDIO Yamaha cxa 5100 Yamaha P2500s (2) Nobsound mini amps (4) Xilica xp4080 3 Klipsch K402MEHs with EV DH1A drivers, and...

I see one pic is with a tablet too...does that mean I can use my own tablet too, or do I buy it from you? Is there a list of equipment that can be controlled? Can I control insteon lighting with a ISY hub too? Can I supply graphics to use?

I just got my 2 signs for the HT back from a friend who made the frames for me. They came out great but one of them got scratched. :( When I order more signs for other components I will most likely order a replacement for the DTS-X one.

The HT is pretty close to being completed... We now have our 4 Atmos speakers installed, and 90% of the ceiling, and wall panels have been completed. Today I also received our DTS-X, Atmos, etc. wall plaques back from a friend who made frames for them all. I will post some pics up when I decide...

We stuffed insulation in ours from the top to the floor.