Yes, knobs would be included in the swap also. If I don't find any takers by next week I am just going to order one from my local dealer. I don't mind owning both black and silver faceplates as my needs may change back again in the future.
I have a 100% flawless silver faceplate on my ref. 50. I'm moving to some different components and would like to have a black faceplate. If you have a perfect black 17" faceplate that you would like to trade or sell PM me.
The remote software is a little clumsy until you get the hang of it. I was very used to and well versed with the pronto edit software. It took me a little while but I was able to basically replicate all of the complex macros and logic I had with my pronto on the SR10.1. Don't give up on the...
Brushed silver ref. 50 with the blue illumination is the bomb!! The best looking silver components are the Parasound halo series only if you have all of them. I used to own a Halo A23. It was nice to look at but it was lonely. It needed a Halo C1 and a A51 to really pull it off.
Brian, Go over to remotecentral.com if you haven't done so already. There might be some device templates with discrete codes that are not in the standard MX-700 IR database. You can import a ref. 50 users complete component file or just a individual device. Sometimes programing a remote from...
Brian good luck with your ref. 50. I really like mine, especially in Silver. If the gaudy gold embossed B&K logo against a silver faceplate's starts to get your nerves you can carefully remove it and lightly sand off the gold plating with 600 grit sand paper. Here's a picture of mine. Looks much...
Be advised if you demo Veritas at a chain like the "Good Guys" they will most likely be set-up incorrectly and if you demo the floorstanders they will most likely be under amplified. I have seen & unfortunately heard that scenario at few stores. I have the full suite of Veritas... 2.4's 2.0c...
Donnie, I'm neither endorsing or rejecting the prospect of a ver. 1.04 upgrade. If maintenance revision upgrades were achieved much like the AVM-20 via s/w downloads with firmware updates then it would or could make sense to upgrade on a more regular basis just to stay current. With the...
I upgraded my ref. 50 from version 1.00 to 1.04. I only upgraded because my eprom got scrambled from an unknown static charge and I could not connect my ref. 50 to my computer to assist in customization. I was happy with ref. 50 at 1.00 and only upgraded since the box was open to change the...