Recent content by Mark Nguyen

Thanks guys ... after looking further into this I might be forced into a short throw projector due to my room's dimensions and screen size of 150" I want to install. Any comparable ones come to mind?

Thanks - I saw this Sony model and a few mentions of the Benq TK810. Anyone has personal experience with this Benq? I am sure the Sony model above is better but is it worth or 3X better? (1300 vs 4900) Debating whether to spend the extra dough or if Benq is good enough.

Hello fellow AV’er, I’m in the market for a new 4K projector and came here for your personal/expert advice on what you would recommend. If you have recently gone thru the same thing and decided to go with XYZ brand/model I’d like to hear your advice. Thanks in advance. Note: It’s dedicated...

Hi, I love the DEfTech line, had them for many yrs and still don't feel a need to upgrade. For 7.1 setup, you'll need 2 fronts, 1 center, 2 sides, 2 rears, and a subwoofer (that's the .1 in the "7.1"). As far as which one to get I would say it depends on how open your check book is :) and...

I believe the correct term is the foam edge? I've attached a picture. Thanks, Mark

I want to glue the rubber piece on my sub back onto its base...they came lose.

Aside from speaker glue, if you can't find it around your area, what is a good replacement glue/adhesive....like find something at Home Depot? Thanks, Mark

You have PM.

YGM.

Dave, this is great. Thanks for the link...ordered 250ft only $100, that's including shipping. Now, I hope it comes in time. :) Mark

Currently, there's 16G wired by the builder but it looks so thin and flimsy...it can't possibly be great for sound could it?? Mark

Hi everyone, I am currently building our home and the drywall is going on very soon in the HT room. Can you guys suggest what in-wall speaker cable to get that does the job and the price is right? My fronts are DefTech BP2000. The run from the rack to the front is about 35-40ft. Thanks a...

Thanks Jon, will check them out. As for the cable, is CAT5 adequate for drive these shakers? I have plenty of CAT5 laying around and figure I would use those instead of buying more speaker wires. Thanks, Mark

Hi, So there's no interference or noise on the power line using these X10 switches? Mark

Hi, I am looking to setup 6 bass shakers and was wondering how many wires I need to run for them. P.S. Any suggestion for a fairly cheap set of 6? Thank you, Mark